Fujitsu S510 - ScanSnap - Document Scanner 시작하기 매뉴얼 - 페이지 28
{카테고리_이름} Fujitsu S510 - ScanSnap - Document Scanner에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu S510 - ScanSnap - Document Scanner 30 페이지. Color image scanner
Fujitsu S510 - ScanSnap - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 (3 페이지), 사양 (2 페이지), 빠른 설치 매뉴얼 (2 페이지), 브로셔 및 사양 (2 페이지), 시작하기 매뉴얼 (28 페이지), 청소 지침 (2 페이지)
![Fujitsu S510 - ScanSnap - Document Scanner 시작하기 매뉴얼](/uploads/products/server2/2440160/2440160.jpg)
5.
Close the ADF.
ADF
You should hear the ADF click when it returns to its
original position.
6.
Turn on the scanner.
ScanSnap Manager icon changes from
7.
Right-click the "ScanSnap Manager" icon
task bar, and select [Check consumable supplies]
from the menu.
8.
In the "Check consumable status" window, click the
[Reset] button of Pad ASSY Count.
The counter is reset to "0".
6.3. Replacing the Pick Roller
Replace the Pick roller following the procedure below.
1.
Remove the document on the Paper chute.
2.
Open the ADF while pulling the Cover open lever.
Paper chute
ADF
Cover open lever
26
3.
Adjust the Side guide to the "A5" size.
4.
Remove the Sheet guide.
Pinch the Pickup tabs on the Sheet guide to pull the
Sheet guide to remove it.
to
.
S
on the
S
5.
Rotate the Pick roller bushing (left side) in the
direction of the arrow.
Pick roller
6.
Remove the Pick roller with its shaft.
Slightly pull up the left part of the Pick roller shaft
(about 5mm), move it towards the left side, and then
raise it to remove from the scanner.
Pick roller shaft
A5
A5
Sheet guide
Pick roller
Pickup tab
Pick roller
bushing
Pick roller
shaft