Fujitsu S510 - ScanSnap - Document Scanner 시작하기 매뉴얼 - 페이지 29
{카테고리_이름} Fujitsu S510 - ScanSnap - Document Scanner에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu S510 - ScanSnap - Document Scanner 30 페이지. Color image scanner
Fujitsu S510 - ScanSnap - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 (3 페이지), 사양 (2 페이지), 빠른 설치 매뉴얼 (2 페이지), 브로셔 및 사양 (2 페이지), 시작하기 매뉴얼 (28 페이지), 청소 지침 (2 페이지)
페이지 인쇄
If the around the pick roller is dirty by paper
-powder, it may cause a scanning error.
Remove the dirt using a soft cloth moistened
with Cleaner F1.
* Do not use water, mild detergent or air-spray.
7.
Remove the Pick roller from its shaft.
Pull out the shaft from the Pick roller while lifting up
its tab.
Tab
If you push up the pick roller tab using your
fingernail, your fingernail may be hurt or get
chipped. If you cannot push it up successfully
with your fingernail, use a paper clip to push
up the pick roller tab.
8.
Attach the new Pick roller to the shaft.
Insert the shaft aligning the protrusion with the slot
on the new Pick roller.
Shaft
9.
Install the Pick roller with its shaft to the scanner.
Insert the right end of the shaft to the roller bushing
(right), and set the shaft to the slot while lowering it.
Shaft
Pick roller
1
2
Pick roller
Slot
Protrusion
Shaft
10. Fix the Pick roller bushing (left) by rotating it in the
direction of the arrow.
Pick roller
Make sure that the Pick roller is
completely attached. Otherwise,
document jams or other feeding errors
may occur.
11. Attach the sheet guide to the scanner.
Pinch the pickup tabs on the sheet guide and attach
the sheet guide to the scanner.
Sheet guide
You should hear the sheet guide click when it
returns to its original position.
ScanSnap S510 Getting Started | 27
Bushing
Pick roller
Pick roller
bushing
Shaft
Pickup tab