Fujitsu S510M - ScanSnap - Document Scanner 시작하기 매뉴얼 - 페이지 18
{카테고리_이름} Fujitsu S510M - ScanSnap - Document Scanner에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu S510M - ScanSnap - Document Scanner 24 페이지. Color image scanner
Fujitsu S510M - ScanSnap - Document Scanner에 대해서도 마찬가지입니다: 설치 절차 (3 페이지), 사양 (2 페이지), 빠른 설치 매뉴얼 (2 페이지), 시작하기 매뉴얼 (35 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지)
페이지 인쇄
5. Daily Care
This chapter describes how to clean the ScanSnap scanner.
WARNING
Fire/Electric Shock
Before cleaning the scanner, unplug the AC adapter
cord from the power outlet.
5.1. Cleaning Materials
Cleaning Materials
Parts No.
Cleaner F1
PA03950-0352
*1) When purchasing the cleaning material, contact the FUJITSU
scanner dealer from whom you purchased the scanner.
*2) It may take long before the cleaner vaporizes if a large quantity
is used. When cleaning the scanner parts, dampen a cloth with
modest quantities of the cleaner. In addition, wipe off the
cleaner completely with a soft lint-free cloth to leave no residue
on the surface of the cleaned parts.
5.2. Cleaning the Scanner Exterior
Clean the scanner exterior and the Paper chute with a dry
cloth moistened with a small amount of neutral detergent
or Cleaner F1.
●
Never use paint thinner or other organic solvents.
ATTENTION
●
During the cleaning, take care not to let water or
other moistures getting into the inside of the
scanner.
●
Do not use aerosol sprays to clean the scanner.
Aerosol sprays cause dust to enter the scanner,
resulting in scanner failure or scanner
malfunction.
5.3. Cleaning Inside of the scanner
Clean inside of the scanner with a cloth moistened with
Cleaner F1.
Accumulated paper-powder and dust inside the scanner can
cause a scanning error.
As a guideline, clean the ADF every 1,000 scans. Note that
this guideline varies according to the type of documents
you are scanning. For example, you have to clean the ADF
more frequently when scanning photocopied documents
with poor toner adhesion or documents with penciled
information.
Clean the ADF according to the following procedure
16 |
Remarks
1 bottle (100ml) *1, *2
Cloth
Neutral detergent
or Cleaner F1
Paint thinner
referring to the illustrations.
CAUTION
The glass surface inside the ADF becomes hot during
the scanner operation.
Before you start cleaning the inside of the scanner,
unplug the AC adapter cord from the outlet, and wait at
least 15 minutes to cool down the scanner.
●
Never use water or neutral detergent to clean
ATTENTION
the inside of the scanner.
●
Do not use aerosol sprays to clean the scanner.
Aerosol sprays cause dirt and dust entering the
scanner, resulting in scanner failure and
scanner malfunction.
1. Pull the Cover open lever and open the ADF.
ADF
Cover open lever
2. Clean the parts indicated in the figure below with a
cloth moistened with the Cleaner F1.
Pad ASSY
Glass (x2)
(Located on the ADF cover and the base unit.)
Plastic rollers (x4)
Eject rollers (x2)
Pick roller
Feed rollers
(x2)