Fujitsu ScanSnap fi-5110C 시작하기 - 페이지 22
{카테고리_이름} Fujitsu ScanSnap fi-5110C에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap fi-5110C 27 페이지. Color duplex workgroup scanner
Fujitsu ScanSnap fi-5110C에 대해서도 마찬가지입니다: 브로셔 및 사양 (2 페이지), 데이터시트 (2 페이지)
페이지 인쇄
Appendix 1
■ Troubleshooting checklist
Symptom
Scanner does not turn
on.
Scanning does not
commence.
Vertical lines appear in
the printed image.
The scanned printed
image appears shifted or
distorted.
Quality of the scanned
image is not satisfactory.
AP-1
TROUBLESHOOTING
Check this item
Have you pressed the power
button on?
Are the AC cable and AC adapter
properly connected to the scan-
ner?
Are you using the correct AC cable
and AC adapter supplied with the
scanner from the manufacture?
Are the documents loaded properly
on to the ADF paper chute?
Is the ADF closed completely?
Is the USB cable cable connected
securely?
Does the Function Number display
indicates an alarm or an error?
The alarm status remain displayed
even after the scanner has been
turned off and on again?
Is the glass dirty?
Have the documents been loaded
correctly?
Is the glass clean?
Remedy
Push the power button in to turn the scan-
ner.
Correctly connect the AC cable and the AC
adapter.
Disconnect the AC cable and the AC
adapter from the scanner, then connect
them again.
If this does not restore the power supply,
contact the store where you purchased the
scanner or an authorized FUJITSU scanner
service provider.
You must use the AC adapter and cable
supplied with your scanner by the
manufacture. Please get the correct AC
adapter and cable to connect to your scan-
ner.
Realign and reload the documents on to
ADF paper chute.
Close the ADF completely.
Connect the cable. (When a USB hub is
used, check the hub's power supply.)
When the Function Number display indi-
cates an alarm or an error, refer to "Chap-
ter 6 TROUBLESHOOTING" in the fi-
5110C Operator's Guide for removing the
alarm or the error.
Turn off and on the power button.
If this does not eliminate the alarm status,
contact the store where you purchased the
scanner or an authorized FUJITSU scanner
service provider.
Clean the glass as instructed in the Opera-
tor's Guide "4. Daily Care".
Reload the documents correctly.
Clean glass and otther dirty locations
around glass and ADF.