Fujitsu ScanSnap iScanner fi-6010N 시작하기 매뉴얼 - 페이지 16
{카테고리_이름} Fujitsu ScanSnap iScanner fi-6010N에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap iScanner fi-6010N 45 페이지. Network adf scanner
Fujitsu ScanSnap iScanner fi-6010N에 대해서도 마찬가지입니다: 사양 (2 페이지), 시작하기 매뉴얼 (21 페이지), 브로셔 및 사양 (2 페이지), 시작하기 매뉴얼 (21 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지)
페이지 인쇄
2.4 Attaching the Keyboard
Cover
The layout of the keyboard may differ according to the
language selected for the operating environment. The
layout of each keyboard cover is prepared according to
language requirements. Take the keyboard cover for the
selected language out of its packaging, and attach it to
the scanner. This scanner is set up for use with an
English (US) keyboard. Therefore, if the scanner is to be
used with an English (US) keyboard attaching a key-
board cover is not required.
Check that the power is turned off
ATTENTION
before attaching the keyboard cover.
1. Clean the surface of the keyboard.
Pay particular attention
to these areas
2. Turn the keyboard cover over and remove the
paper backing from the top strip of double-
sided tape.
Underside
3. Align the top edge of the keyboard cover with
the protruding guides, and firmly smooth the
double-sided tape down.
Align and attach the top-left corner first, then the
center, and last the top-right corner.
Paper backing tape
Top-left guide
Top
attachment
area
4. Flip up the keyboard cover and remove the
paper backing from the bottom strip of double-
sided tape.
Paper
backing tape
5. Gently stretch the keyboard cover forward and
smooth the double-sided tape down.
Bottom
attachment area
Continue setting up the network.
5
Top-center guide
Top-right guide
Flip up the
keyboard cover