Fujitsu ScanSnap iScanner fi-6010N 시작하기 매뉴얼 - 페이지 15
{카테고리_이름} Fujitsu ScanSnap iScanner fi-6010N에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanSnap iScanner fi-6010N 45 페이지. Network adf scanner
Fujitsu ScanSnap iScanner fi-6010N에 대해서도 마찬가지입니다: 사양 (2 페이지), 시작하기 매뉴얼 (21 페이지), 브로셔 및 사양 (2 페이지), 시작하기 매뉴얼 (21 페이지), 청소 지침 (2 페이지), 청소 지침 (2 페이지)
페이지 인쇄
Chapter 2
2.1 Space Requirements
The following space is required to set up the scanner:
Depth: 700 mm (28 in.)
Width: 400 mm (16 in.)
Height: 500 mm (20 in.)
2.2 Installing the Scanner
When lifting the scanner, always
ARNI N G
hold it by the indentations on the
bottom of each side to ensure a
stable grip.
Holding the scanner in any other
way may cause it to be dropped
or damaged.
1. Place the scanner at its installation site.
2. Attach the ADF paper chute.
Hold the ADF paper chute and insert its tabs into
the corresponding slots in the scanner as shown in
the following figure.
The side guides of the ADF paper chute should
face up.
Tab
2.3 Connecting the Cables
1. Connect the AC cable to the AC adapter.
Use only the AC adapter provided by
ATTENTION
the manufacturer.
Setting up the Scanner
old the scanner by
these side indentations
when lifting.
2. Connect the AC adapter connector to the scan-
ner's DC inlet.
3. Connect the LAN cable to the LAN connector.
4. Attach the back cover.
Attach the cover with the connected AC cable
and LAN cable protruding out of the lower part
of the cover.
Tab
To make sure the cover is properly attached,
insert the right and left tabs at the same time.
5. Connect the other end of the LAN cable to the
network hub.
6. Insert the AC cable into a power outlet.
The power is connected but the scanner is not
yet ready for operation.
4