Fujitsu ScanSnap iScanner fi-6010N Handbuch "Erste Schritte - Seite 15

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Scanner Fujitsu ScanSnap iScanner fi-6010N herunter. Fujitsu ScanSnap iScanner fi-6010N 45 Seiten. Network adf scanner
Auch für Fujitsu ScanSnap iScanner fi-6010N: Spezifikationen (2 seiten), Handbuch "Erste Schritte (21 seiten), Broschüre & Specs (2 seiten), Handbuch "Erste Schritte (21 seiten), Anweisungen zur Reinigung (2 seiten), Anweisungen zur Reinigung (2 seiten)

Seite drucken

Fujitsu ScanSnap iScanner fi-6010N Handbuch

Chapter 2

2.1 Space Requirements

The following space is required to set up the scanner:

Depth: 700 mm (28 in.)

Width: 400 mm (16 in.)

Height: 500 mm (20 in.)

2.2 Installing the Scanner

When lifting the scanner, always

ARNI N G

hold it by the indentations on the

bottom of each side to ensure a

stable grip.

Holding the scanner in any other

way may cause it to be dropped

or damaged.

1. Place the scanner at its installation site.

2. Attach the ADF paper chute.

Hold the ADF paper chute and insert its tabs into

the corresponding slots in the scanner as shown in

the following figure.

The side guides of the ADF paper chute should

face up.

Tab

2.3 Connecting the Cables

1. Connect the AC cable to the AC adapter.

Use only the AC adapter provided by

ATTENTION

the manufacturer.

Setting up the Scanner

old the scanner by

these side indentations

when lifting.

2. Connect the AC adapter connector to the scan-

ner's DC inlet.

3. Connect the LAN cable to the LAN connector.

4. Attach the back cover.

Attach the cover with the connected AC cable

and LAN cable protruding out of the lower part

of the cover.

Tab

To make sure the cover is properly attached,

insert the right and left tabs at the same time.

5. Connect the other end of the LAN cable to the

network hub.

6. Insert the AC cable into a power outlet.

The power is connected but the scanner is not

yet ready for operation.