Fujitsu ScanSnap iScanner fi-6010N Manual de iniciação - Página 15

Procurar online ou descarregar pdf Manual de iniciação para Scanner Fujitsu ScanSnap iScanner fi-6010N. Fujitsu ScanSnap iScanner fi-6010N 45 páginas. Network adf scanner
Também para Fujitsu ScanSnap iScanner fi-6010N: Especificações (2 páginas), Manual de iniciação (21 páginas), Brochura e especificações (2 páginas), Manual de iniciação (21 páginas), Instruções de limpeza (2 páginas), Instruções de limpeza (2 páginas)

Imprimir página
Fujitsu ScanSnap iScanner fi-6010N Manual de iniciação
Chapter 2

2.1 Space Requirements

The following space is required to set up the scanner:
Depth: 700 mm (28 in.)
Width: 400 mm (16 in.)
Height: 500 mm (20 in.)

2.2 Installing the Scanner

When lifting the scanner, always
ARNI N G
hold it by the indentations on the
bottom of each side to ensure a
stable grip.
Holding the scanner in any other
way may cause it to be dropped
or damaged.
1. Place the scanner at its installation site.
2. Attach the ADF paper chute.
Hold the ADF paper chute and insert its tabs into
the corresponding slots in the scanner as shown in
the following figure.
The side guides of the ADF paper chute should
face up.
Tab

2.3 Connecting the Cables

1. Connect the AC cable to the AC adapter.
Use only the AC adapter provided by
ATTENTION
the manufacturer.

Setting up the Scanner

old the scanner by
these side indentations
when lifting.
2. Connect the AC adapter connector to the scan-
ner's DC inlet.
3. Connect the LAN cable to the LAN connector.
4. Attach the back cover.
Attach the cover with the connected AC cable
and LAN cable protruding out of the lower part
of the cover.
Tab
To make sure the cover is properly attached,
insert the right and left tabs at the same time.
5. Connect the other end of the LAN cable to the
network hub.
6. Insert the AC cable into a power outlet.
The power is connected but the scanner is not
yet ready for operation.
4