Brother HL-2270DW 네트워크 사용 설명서 - 페이지 24

{카테고리_이름} Brother HL-2270DW에 대한 네트워크 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother HL-2270DW 47 페이지. How do i configure the wireless printer using wi-fi protected setup or aoss and install the printer driver in windows?
Brother HL-2270DW에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (36 페이지), 빠른 설정 매뉴얼 (36 페이지), 설치 매뉴얼 (5 페이지), 빠른 설정 매뉴얼 (35 페이지), 자주 묻는 질문 및 문제 해결 (6 페이지)

페이지 인쇄

Configuring your machine for a wireless network (For HL-2270DW)

Wait until the Ready LED of your machine indicates Connected. The Ready LED will turn on for 5

minutes. (See the table below) This indication means the machine has successfully connected to your

WLAN access point/router. You can now use your machine in a wireless network.

If the LED indicates Connection Fail (See the table below), the machine has not successfully connected

to your WLAN access point/router or the entered PIN code is invalid. Make sure you enter the correct

PIN code, and try starting from c again. If the same message is indicated again, reset the print server

back to its factory default settings and try again. For resetting, see Reset the network settings to the

factory default on page 26.

If the LED indicates No Access Point (See the table below), the machine has detected no WLAN access

point/router on your network. Make sure you place the Brother machine as close to the WLAN access

point/router as possible with minimal obstructions, and try starting from c again. If the same message

is indicated again, reset the print server back to its factory default settings and try again. For resetting,

see Reset the network settings to the factory default on page 26.

A WLAN report will also be printed with the connection status. If there is an error code on the printed

report refer to Troubleshooting in the Quick Setup Guide.

LED indications when using the one-push wireless setting mode

LEDs

Setting WLAN

Toner

(Yellow)

Drum

(Yellow)

Error

(Orange)

Ready

(Green)

The LED will blink (turn on for 0.2 seconds and off for 0.1 second).

The LED will turn on for 5 minutes.

The LED will blink (turn on for 0.1 second and off for 0.1 second) for 30 seconds.

You have completed the wireless setup. To install the printer driver, please choose

"Install Printer Driver" from the CD-ROM menu.

Connected

Connection fail

No Access Point