Fujitsu ETERNUS DX100 S3 구성 매뉴얼 - 페이지 22

{카테고리_이름} Fujitsu ETERNUS DX100 S3에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ETERNUS DX100 S3 28 페이지. Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX100 S3에 대해서도 마찬가지입니다: 수동 서버 연결 구성 (12 페이지), 수동 서버 연결 구성 (12 페이지), 구성 매뉴얼 (13 페이지), 설정 매뉴얼 (15 페이지), 안전 주의사항 (12 페이지)

페이지 인쇄

1. Hardware

Chapter 7

Checking Connections

7.1

Turning on the Devices

To turn on the connected devices, use the following procedure:

Turn on any devices (such as LAN switches) on the LAN path between the ETERNUS DX and server.

After checking that the Ready (or equivalent) LED of the LAN switch is lit, turn on the ETERNUS DX

storage systems.

After checking that the ETERNUS DX's Ready LED is lit, turn on the server.

7.2

Setting Up the Server to Recognize the Logical Units

Make the server recognize the logical units (LUN) set in the ETERNUS DX storage systems.

Use the "ioscan" command to check which devices are connected.

Enter as follows for LegacyView (old format) results:

# ioscan -fn

Enter as follows for AgileView (HP-UX11iv3 and newer format) results:

# ioscan -fnN

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX

P3AM-3402-14ENZ0