Indesit HOTPOINT LUCE DX1032CX 서비스 매뉴얼 - 페이지 12

{카테고리_이름} Indesit HOTPOINT LUCE DX1032CX에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit HOTPOINT LUCE DX1032CX 39 페이지. Built-in touch control electronic multifunction 60 cm double oven

페이지 인쇄

Indesit

Company

TEST PROCEDURE FOR OVEN TEMPERATURE MEASUREMENTS

The following is the preferred method to be used when calculating any Mean Oven Centre

Temperature (M.O.C.T.).

Equipment: - Surface Temperature Probe

Digital Thermometer

Thermocouple

Temperature Test Gate

1. Remove all cooking utensils from the oven cavity and place a single rod shelf on the runners

nearest the centre of the oven.

2. Fit the thermocouple leads to the temperature test gate so that the thermocouple junction is

positioned as near to the centre of the gate as possible. See Fig. 5.

3. Position the gate on the centre of the rod shelf so that the large plates on the gate are facing

the direct heat source.

4. Route the thermocouple wire out through the front of the oven and close the oven door.

5. Turn the oven thermostat up past the 200°C setting, then slowly reduce the temperature to

200°C.

6. Measure the temperature of the oven at the fourth thermostat overshoot and the fourth

temperature undershoot. See Fig. 6.

OVERSHOOT

Maximum temperature reached after the thermostat indicator cuts out.

UNDERSHOOT Minimum temperature reached after the thermostat indicator cuts in.

CALCULATING THE MEAN OVEN CENTRE TEMPERATURE

Fig. 6

Service Manual UK

Part No. 5600081

Part No. 5700036

Part No. 5700066

Part No. 5600041

Fig. 5

Note: The Thermocouple junction

should not touch any

surrounding metalwork.

12 of 39

English