AEG 8359 D 설치 및 운영 지침 매뉴얼 - 페이지 5

{카테고리_이름} AEG 8359 D에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 8359 D 18 페이지. Fume extractor hood

Electrical connections

It must be ensured that the voltage and current indicated on the rating

plate agree with the voltage of the user to electricity supply.

If the appliance has been equipped with a mains lead with a moulded-on

type plug, the following regulations must be comply with:

The plug moulded on to the lead incorporates a fuse. For replacement,

use a 5 amp BS1362 fuse. Only ASTA approved or certified fuses should

be used. If the fuse cover/carrier is lost, a replacement cover/carrie must

be obtained from an electrical goods retailer. If the socket outlets are not

suitable for the plug fitted to the appliance, then the plug must be cut off

and destroyed for safety reasons, and an appropriate plug be fitted.

When wiring the plug ensure that all strands of wire are securely retained

in each terminal. Do not forget to tighten the mains lead clamp on the plug.

Electrical connections

230 V - using fixed power supply line with plug.

Fuse rating

(The unit should only be connected up by an authorized electrician).

See rating plate for further information.

It is recommended that the socket for the plug is sited above the cooker

hood or above the overhead cabinet.

This has 2 advantages:

1) The socket is not visible.

2) The appliance can easily be unplugged when necessary.

If a fixed connection is required the cooker hood should be connected by

an electrical installer registered with a competent electricity company. An

isolating device is to be provided on the fixed wiring side. Switches with

a contact opening of more than 3mm apply as isolating devices.

These include-automatic cut-out switches, fuses and contactors (VDE

0730, s. 7, Part1).

13 amps