Kohler 20341T-PNE-CP 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Kohler 20341T-PNE-CP에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 20341T-PNE-CP 10 페이지. Pneumatic in-wall tank with frame short height

3. Carefully loosen the four locking screws by rotating them clockwise until
the screw slots align with open tabs.
Warning: No tools or excessive force should be used to rotate the locking
screws to the ''OPEN'' position.
4. Disassemble faceplate supporting frame as shown.
5. Rotate the shut off valve actuator handle clockwise to
open and anti-clockwise to close.
6. Unscrew the hose from the inlet valve. Press the release
clip and lift to remove the inlet valve.
7. Push the clip of the toilet detergent box and lift to remove
from cistern.
8. Disconnect the oultet valve actuator arms for the full and
reduced flush by pushing towards the centre of the cistern
while applying pressure to both top and bottom of the pivot.
Remove the pneumatic actuator assembly by lifting the rear
of the frame to release the snap clips. Hold the pneumatic
hose ends and pull up to remove.
1310920-A02-A
Locking bolt
Close
Open
Valve
Quick release
connector
Nut
Clip
Snap (locked)
Lever snap
- 8 -
Locking plate