Kohler 20341T-PNE-CP 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Kohler 20341T-PNE-CP에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 20341T-PNE-CP 10 페이지. Pneumatic in-wall tank with frame short height

페이지 인쇄

6. To lock the bolts in position turn the bolt counter-clockwise until the tab on the

bolt head is vertical to LOCK mark.

Note: Do not use excessive force - hand tighten only.

7. Trim the length of the locking bolts if required.

8. Fit the red full flush air hose and the blue reduced flush air hose to the faceplate.

9. Push the faceplate into the locking plate until it locks into place.

Note: Cut the excessive parts of the air hose if necessary and

fix it onto the tank fastener.

10. The cistern should now be ready to use.

A3-2 :

Remote locking plate installation

1. 7~20mm thickness is recommended for

the finished wall and at least 80mm gap

for faceplate.

2. Use four screws to fix locking plate by

four pinch plates to the wall.

3. Follow the steps 8-10 of A3-1 to complete the

faceplate installation.

A3-3 :Remote installation of flush button shield

1. Add a nog to studs where you want to install the faceplate to mo

2. Drill 4 holes with diameter of 10mm and depth

of 16mm are needed to locate the locking plate

bolts.

Drill 10mm hole for air hose on the side of sheild.

3. Mount the shield on nog using self-tapping screws.

4. Do not cut the shield as the full lenght of shield is

needed to accomodate the minimum space that is

required for faceplate.

5. Follow the steps 5-10 of A3-1 to complete the

faceplate installation.

A3-4 :Press from front: fix four plates with screws

1. Cut the cable tie of the air hose and pull it out from the tank

2. Ensure the tank is accessable through front or top for future mai n tenance.

3. Fix the four plates with screws and then fix the locking plate.

4. No direct contact between the faceplate and the tank as the 80mm gap is

required to support the faceplate thickness.

5. 7~20mm thickness recommended for the finished wall.

6. Follow the steps 8-10 of A3-1 to complete the faceplate installat i on.

1310920-A02-A

Locking plate bolt

Connect to blue

air hose (half flush)

Fastener

Connect to red

air hose (full flush)

Faceplate

Locking plate

Full flush

Pinch plates

Locking plate

Screw

unt the shield on.

177

Position of locking

bolt through holes on nog

Locking plate

Air hose

-6-

Faceplate

Locking plate

Locking

Pinch plate

plate

Finished

Air hose

wall

Air hose

ø10 mm hole through hose

Fix sheild in wall

ø10 mm hole, depth

16mm locking bolt through

Space required

Pinch plate

7~20mm recommended

Finished wall

At least 80mm

gap reserved

Half

Flush

7~20mm

recommended

At least 80mm

gap required

Nog

Finished

wall