AQC MAXIPLY DMP-170S 소유자 매뉴얼 - 페이지 16

{카테고리_이름} AQC MAXIPLY DMP-170S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQC MAXIPLY DMP-170S 20 페이지. Open type dust collector

11.2

Remplacement of the filter enveloppe

1 . Unfasten the attachment bars at the bottom of the filter envelope located on all four (4) sides

of the collector.

2 . Remove the upper filter envelope support rods (rubber bands for optional manual shaker

system)

3. Remove the filter envelope from the lower frame.

4. Position the new filter envelope on the frame and reinsert the support rods. Ensure the

fasteners are tightened and the filter envelope is well in place.

5. Reinstall the attachment bars or rubber bands for the optional manual shaker system.

The chart indicated below shows different inspections and the frequency at which they should be

performed.

Frequency of

inspections

Daily

Weekly

Semi-

annually/Annually

Components

Dust collector

Filter envelope

Dust collector

Multiple pocket type dust collector

Procedures

Check for dust leaks around the air inlet and the filter en-

velope frame. Refer to Troubleshooting on page 17 of this

manual.

Check dust level in dust storage bin. Empty.

Check for leaks on the filter envelope. Repair or replace if

necessary. Ensure the filter envelope is securely fastened.

Examine, clean and apply paint touch-ups if necessary.

If needed, lubricate the shaker and shaft rocking system

using lithium base grease.