AQC MAXIPLY DMP-170S 소유자 매뉴얼 - 페이지 9

{카테고리_이름} AQC MAXIPLY DMP-170S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQC MAXIPLY DMP-170S 20 페이지. Open type dust collector

Multiple pocket type dust collector

4. Referring to figure 6, install top panels # 5 and 6. The panels with holes must be facing the

dust collector inlet.

5. The bottom part of the filter envelope is bolted to the filter frame section of the hopper.

This is to ensure the filter envelope is not damaged during freight. at the factory. The upper

part of the filter needs to be attached to the part of the dust collector frame. In order to do

so, insert the rods through the filter sleeves in both # 5 panels. Tighten with the fasteners

(supplied). For the installation of the optional manual shaker system, refer to the installation

section of this device (page 10).

SUPPORT RODS

PANEL #5

(WITH HOLES)

Figure 6 : Assembly step 4

ASSEMBLY STEP 4

Figure 7 : Assembly step 5

ASSEMBLY STEP 5

PANEL #6

(NO HOLES)

Figure 7

FILTER ENVELOPE