AQC MAXIPLY DMP-170S Kullanıcı El Kitabı - Sayfa 9

Toz Toplayıcı AQC MAXIPLY DMP-170S için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AQC MAXIPLY DMP-170S 20 sayfaları. Open type dust collector

Sayfayı Yazdır

Multiple pocket type dust collector

4. Referring to figure 6, install top panels # 5 and 6. The panels with holes must be facing the

dust collector inlet.

5. The bottom part of the filter envelope is bolted to the filter frame section of the hopper.

This is to ensure the filter envelope is not damaged during freight. at the factory. The upper

part of the filter needs to be attached to the part of the dust collector frame. In order to do

so, insert the rods through the filter sleeves in both # 5 panels. Tighten with the fasteners

(supplied). For the installation of the optional manual shaker system, refer to the installation

section of this device (page 10).

SUPPORT RODS

PANEL #5

(WITH HOLES)

Figure 6 : Assembly step 4

ASSEMBLY STEP 4

Figure 7 : Assembly step 5

ASSEMBLY STEP 5

PANEL #6

(NO HOLES)

Figure 7

FILTER ENVELOPE