AQC MAXIPLY DMP-170S Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odpylacz AQC MAXIPLY DMP-170S. AQC MAXIPLY DMP-170S 20 stron. Open type dust collector

Multiple pocket type dust collector
 4. Referring to figure 6, install top panels # 5 and 6. The panels with holes must be facing the
dust collector inlet.
 5. The bottom part of the filter envelope is bolted to the filter frame section of the hopper.
This is to ensure the filter envelope is not damaged during freight. at the factory. The upper
part of the filter needs to be attached to the part of the dust collector frame. In order to do
so, insert the rods through the filter sleeves in both # 5 panels. Tighten with the fasteners
(supplied). For the installation of the optional manual shaker system, refer to the installation
section of this device (page 10).
SUPPORT RODS
PANEL #5
(WITH HOLES)
Figure 6 : Assembly step 4
ASSEMBLY STEP 4
Figure 7 : Assembly step 5
ASSEMBLY STEP 5
PANEL #6
(NO HOLES)
Figure 7
FILTER ENVELOPE
9