AQC MAXIVIBE AMV-1140 소유자 매뉴얼 - 페이지 11
{카테고리_이름} AQC MAXIVIBE AMV-1140에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQC MAXIVIBE AMV-1140 20 페이지.
페이지 인쇄
Shaker type dust collector
10 DUCTING SYSTEMS
•
The dust collector should be installed as close as possible to the machines creating the dust.
This is to minimize the length of ductwork.
•
If possible, do not install short radius elbows or bends.
•
Install taps and branches having a 30 degree slope or less.
•
Do not install straight 90 degree taps (T's).
•
Join ductwork and branches using self tapping screws and silicone.
11 START-UP
11.1
Check list
Before starting the collector for the first time, the steps listed below should be followed to ensure
the collector will work properly.
•
Remove all objects in the vicinity of collector inlet and outlet.
•
Check for proper installation of all accessories and optional equipment.
11.2
Shaker system
•
Check if filter envelope upper frame is in place.
•
For automatic shaker systems, check if the connecting rod tied to the frame and reducer is
fixed and solid.
11.3
Electrical connection
•
Check if electrical connections are watertight and proper electrical current is provided.
•
Check if all remote controls (if supplied) are connected to the control panel and all switches
are at the "OFF" position.
•
Supply power to the collector.
•
Start the fan and shut it down immediately. Check motor rotation.
WARNING!
The electrical connection must be performed by a certified
electrician and by following the local building rules and
regulations. For safety measure, disconnect all electrical
power prior to installation.
11