Aqua Lung CORE 서비스 매뉴얼 - 페이지 9

{카테고리_이름} Aqua Lung CORE에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Lung CORE 18 페이지.

페이지 인쇄

Fit the tension pin (AP1151) into its

position, centre it. Gently unscrew

the adjusting screw until it applies

sufficient tension on the tension pin

that prevent it from falling out.

11. Fit a new lubricated O-

ring (AP1438) on the

Venturi lever (129909).

12. While holding the lever (129178) down, insert the valve

spindle (129146) in the Venturi lever (129909).

13. While holding the lever (129178) down, and placing the

Venturi lever up, insert the assembly in the case (129931

or 129932) until stop.

Make sure the valve

spindle planes (129146)

are well placed in case

planes.

14. Fit a new lubricated O-ring

(124706)

the

spindle, thread side and

push it against the case

(129931 or 129932).

Service Manual Core 2

Rev. 05/2015

valve

For standard version:

the insert screw (127818) on

the valve spindle. Tighten to

0.3 m.kg (2.17 ft.lb).

For supreme version and

octopus:

screw the heat

exchanger

the

spindle. Tighten to 0.5 m.kg

(3.7 ft.lb).

stage

15. While placing the flat side of the case (129931 or 129932)

at eye level, screw the valve seat (AP2033) with a flat

screwdriver, until the lever (129178) lever is about 4mm

below the level of the case edge.

Unscrew the valve seat to raise the lever up.

Screw the valve seat again until the lever slightly move.

16. Using a 4 mm Allen key, screw the adjusting screw

(129162) of :

3/4 of turn for standard version

1 turn and 1/4 of turn for supreme version and

octopus

17. Lever adjustment:

Connect the tool (122046 + 122041) on the 2

the hose (124567) on the tool. Connect this system to its

stage.

Put

the

pressure. Slide tool (125727)

flat side (without drop) along

the top edge of the case. The

lever should touch the tool but

should not

airflow. Screw or unscrew the

valve seat (AP2033) thanks to

the tool (122046 + 122041).

Screwing the valve seat, take down the lever.

Unscrewing the valve seat, raise the lever.

Turn off the air supply and purge the second stage.

screw

valve

Service Manual Core 2

regulator

under

produce

stage

stage and