CP Electronics MWS3A-AT-PRM 제품 설명서 - 페이지 8

{카테고리_이름} CP Electronics MWS3A-AT-PRM에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CP Electronics MWS3A-AT-PRM 17 페이지. Rd ceiling microwave presence detector-switching
CP Electronics MWS3A-AT-PRM에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)

페이지 인쇄

Basic programming

Step 2: Set-up sensor functionality

Detection Mode

The Detection Mode for the output Channel 1 can be set to

behave in Presence or Absence mode:

 Presence mode allows a channel to turn on when

movement is detected. Once turned on, if no movement

is detected the Time Adjustment (10 minutes by

default) the channel will turn off.

 Absence mode requires the channel to be turned on by

some other means (e.g. by issuing a Scene Select

message via an Input Unit or IR Handset). Once turned

on, if no movement is detected for period of time (the

Time Adjustment) the channel will turn off.

In either case, sensitivity to movement of the Microwave

sensor (Channel 3) can be adjusted using the Sensitivity

parameter (set to 5 by default).

HINT: To assist in setting the Sensitivity, turn on the Walk

Test LED which will flash red when movement is detected.

By default when the detector turns on Local Scene 1 is

selected. When the detector turns off Local Scene 20 is

selected. See 'Scenes Used for Occupancy Detection' in

Step 3 for further details.

Switch Level On/Off

Occupancy detection can be made dependant on the

ambient light level using the Lux On Level and Lux Off

Level parameters.

Note: for applications where there is only one channel of lighting

being controlled in a room there is no need to select the channel

number.