CP Electronics MWS3A-AT-PRM 제품 설명서 - 페이지 9
{카테고리_이름} CP Electronics MWS3A-AT-PRM에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CP Electronics MWS3A-AT-PRM 17 페이지. Rd ceiling microwave presence detector-switching
CP Electronics MWS3A-AT-PRM에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)
페이지 인쇄
Step 3: Re-program scenes
The MWS3A-AT-PRM has capacity to store 20 Local
Scenes and 120 Area Scenes. By default all Scenes are
pre-programmed with the following channel levels, but
these can be changed as required:
Local Scenes
1
2
3
Ch1 on
on
on
Area Scenes
101 102 103 104 105 106 ...
Ch1 on
on
on
NOTE: Local Scene 20 and Area Scene 120 are
designated 'off' scenes within a system and should
normally be programmed with all channels off or at zero.
Scenes can be recalled by using an IR Handset or by a
switch/button plate via an AT-BB-IN Input Unit.
4
5
6
...
19
on
on
on
...
on
119 220
on
on
on
...
on
Scenes Used for Occupancy Detection
If movement is detected (in Presence mode), Local On
Scene 1 is selected. By default this switches Channel 1
On.
If no movement is detected for the Time Adjustment Period
20
(in Presence or Absence mode), Local Off Scene 20 is
selected. By default this switches Channel 1 Off.
off
NOTE: These 'On' and 'Off' Scene selections cannot be
changed using the UHS4 handset. You can, however,
reprogram, on or off values, for Scenes 1 and 20 if
off
required.
Basic programming
Note: + and - will toggle between
On and Off.
9