CP Electronics MWS3A-DD-LV 제품 설명서 - 페이지 7
{카테고리_이름} CP Electronics MWS3A-DD-LV에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CP Electronics MWS3A-DD-LV 13 페이지. Ceiling microwave presence detector - dali / dsi 12-24v ac/dc
CP Electronics MWS3A-DD-LV에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)
페이지 인쇄
When power is applied to the unit, the load will turn on immediately.
Set the timeout to 10 seconds, vacate the room or remain very still and wait for the load to switch off .
Check that the load switches on when movement is detected.
The unit is now ready for programming.
What if the load does not turn ON?
Check that the supply to the circuit is good.
If the detection range is smaller than expected, check the diagram on page 2. Adjusting the angle of the sensor head
slightly may improve the detection range. If still reduced it may be compromised by the ceiling construction /
material. Add the supplied 20mm spacer ring. See page 4 for fitting details.
HINT: The Walk Test LED function can be used to check that the unit is detecting movement in the required area.
What if the load does not turn OFF?
Ensure that the area is left unoccupied for longer than the Time Out Period.
Ensure that the sensor is not adjacent to circulating air, heaters or lamps.
Power-up test procedure
Fault finding
7