DG UDP10G-IP 설정 매뉴얼 - 페이지 10
{카테고리_이름} DG UDP10G-IP에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DG UDP10G-IP 18 페이지. Fpga setup with cpu demo
페이지 인쇄dg_toeudp10gip_fpgasetup_intel.doc
7) Open NiosII command shell.
a. Type "nios2-terminal" to run the console.
b. Input '0' to initialize TOE10G-IP/UDP10G-IP in client mode (asking PC MAC address
by sending ARP request).
c. Default parameter in client mode is displayed on the console.
If Ethernet connection has the problem and the status is linked down, the error message
is displayed on the console instead of welcome message, as shown in Figure 1-11.
26-Aug-20
Figure 1-9 Run NiosII terminal
Figure 1-10 Message after system boot-up
Figure 1-11 Error message when cable is linked down
Page 10