DGF Fabrications N2 설치 및 유지 관리 지침 매뉴얼 - 페이지 9

{카테고리_이름} DGF Fabrications N2에 대한 설치 및 유지 관리 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DGF Fabrications N2 14 페이지. Gas effect fires (natural gas & lpg) for decorative purposes only

페이지 인쇄

As this is a Special Decorative Gas fire there is no exact pattern for pebble layouts, however, the diagrams

below are intended purely as a GUIDE to illustrate the general principles. It is important to leave spaces of

approx 15mm - 20mm between the pebbles to ensure good secondary aeration. Do not overload the fire, it

will spoil not only the appearance of the fire but may cause the fire to soot. Do not put more than 2 layers of

simulated pebbles on fire. Large pebbles going first to smaller being at the top. Depending on the size of the

fire it might not be necessary to use all the simulated pebbles supplied.

Run the fire for approximately 10 minutes and then, if required, adjust the simulated pebbles to give desired

effect using suitable non combustible tool.

Please note: Pebbles of a light colouring will soot very quickly. To clean, use a soft brush when fire is cold.

Guide:

Layer 1 (base layer)

Guide:

Layer 2 (top layer)

Units 1-3 Vulcan St, Edward St Industrial Estate, Darlington. DL1 2UL – Tel: 01325 281304; Fax: 01325 481889

Layout for Simulated Pebbles

DGF Fabrications;