Dell Inspiron 2100 시스템 참조 매뉴얼 - 페이지 18

{카테고리_이름} Dell Inspiron 2100에 대한 시스템 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Inspiron 2100 45 페이지. Vga card installation instructions
Dell Inspiron 2100에 대해서도 마찬가지입니다: 여기에서 시작 (2 페이지), 설정 및 기능 정보 (8 페이지), 빠른 참조 매뉴얼 (17 페이지), 서비스 매뉴얼 (38 페이지), 사양 (2 페이지), 설치 지침 (1 페이지)

페이지 인쇄
Dell Inspiron 2100 시스템 참조 매뉴얼
To remove the upper 3.5-inch drive plate and install a new drive:
1.
Remove the front
panel.
2.
Remove the 3.5-inch front panel
3.
Rotate the power supply
away from the system board. While holding the power supply, place the computer in the upright position.
4. Remove the metal plate covering the bay by using a screwdriver to pop out the metal plate from the left or right side of the computer frame.
5. Remove the extra rails from the inside front of the computer frame.
6. Install the rails on the sides of the drive.
The rails are marked "L" for installation on the left side of the drive and "R" for the right side of the drive.
7. Slide the drive assembly into the drive bay.
8. Connect a power supply cable and drive cables to the drive.
Lower 3.5-Inch Floppy Drive
To remove the 3.5-inch floppy drive from the lower bay:
1.
Remove the front
panel.
2.
Rotate the power supply
away from the system board.
3. While holding the power supply, place the computer in the upright position.
4. Disconnect the power and interface cables from the back of the floppy drive.
5. Press the two drive-release rail tabs, and slide the drive out of the drive bay.
Before you install the new drive, install the drive-release rails on the sides of the replacement floppy drive.

5.25-Inch Drive

1 Drive bay plate
insert.
1 Drive-release rail tabs (2)