Dell PowerEdge 6800 문제 해결 매뉴얼 - 페이지 15

{카테고리_이름} Dell PowerEdge 6800에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 6800 16 페이지. Installation and troubleshooting guide (.htm)

Removing the Trim Panel

1 Lay the system on its cover as shown in Figure 1-7.

Figure 1-7. Removing the Trim Panel

hex-head Phillips screws (6)

2 Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the side

of the trim panel. See Figure 1-7.

3 Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the back

of the system.

4 Slide the trim panel backward and then remove the trim panel from the chassis.

5 If not already present on the system, install the six shoulder screws included with the kit,

attaching three screws to each side. See Figure 1-7.

NOTE:

The shoulder screws must be tightened firmly enough (10.8 to 13.2 in-lbs of torque) to

support the weight of the system in the rack and to prevent loosening.

The system is ready to install in the rack.

shoulder mounting

screws (6)

Tower-to-Rack Conversion Guide