Dell PowerEdge 6800 Instrukcja rozwiązywania problemów - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja rozwiązywania problemów dla Serwer Dell PowerEdge 6800. Dell PowerEdge 6800 16 stron. Installation and troubleshooting guide (.htm)

Drukuj stronę

Removing the Trim Panel

1 Lay the system on its cover as shown in Figure 1-7.

Figure 1-7. Removing the Trim Panel

hex-head Phillips screws (6)

2 Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the side

of the trim panel. See Figure 1-7.

3 Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the back

of the system.

4 Slide the trim panel backward and then remove the trim panel from the chassis.

5 If not already present on the system, install the six shoulder screws included with the kit,

attaching three screws to each side. See Figure 1-7.

NOTE:

The shoulder screws must be tightened firmly enough (10.8 to 13.2 in-lbs of torque) to

support the weight of the system in the rack and to prevent loosening.

The system is ready to install in the rack.

shoulder mounting

screws (6)

Tower-to-Rack Conversion Guide