Dell PowerEdge FD332 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Dell PowerEdge FD332에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge FD332 46 페이지.
Dell PowerEdge FD332에 대해서도 마찬가지입니다: 시작하기 (2 페이지)

NOTE:

It is recommended that you always use an antistatic mat and antistatic strap while working on components inside the

system.

Before working inside your system

Turn off the compute sled(s) to which the storage sled is mapped, by using the CMC, iDRAC, or the power button on the compute

sled.

When the sled is turned off, its front panel power indicator is off.

The storage sled also turns off.

Remove the storage sled from the enclosure.

Install the I/O connector cover.

Remove the I/O connector cover.

Install the storage sled in the enclosure.

Turn on the compute sled(s) to which the storage sled is mapped.

The storage sled turns on after the compute sled is turned on.

You may need the following items to perform the procedures in this section:

•

#1 and #2 Phillips screwdrivers

•

T15 Torx driver

Removing a storage sled

Prerequisites

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple

repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.

Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that came with the product.

CAUTION:

Removing the storage sled from the enclosure when the storage sled is powered on results in loss of data.

CAUTION:

To prevent damage to the storage sled locks, use a #2 Phillips screwdriver to turn the sled locks to lock or unlock

positions.

Ensure that you read the Safety instructions provided in this document.

Turn off the compute sled(s) to which the storage sled is mapped, by using the CMC, iDRAC, or the sled power button.

Keep the #2 Phillips screwdriver ready.

Installing and removing storage sled components