Dell PowerVault 122T LTO 사용자 설명서 - 페이지 33

{카테고리_이름} Dell PowerVault 122T LTO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 122T LTO 40 페이지. Lto autoloader
Dell PowerVault 122T LTO에 대해서도 마찬가지입니다: 핸드북 (28 페이지), 사용자 설명서 (42 페이지)

페이지 인쇄

2. From the Home screen or main menu, press + or - until Commands appears on the top line of the LCD screen.

3. Press Enter to access the available options.

4. Press + or - until Import appears on the LCD screen, and then press Enter.

5. Press + or - until the desired slot number appears on the LCD screen and press Enter. You are not given the option to import a cartridge to an occupied

slot.

6. When Insert Cartridge Slot appears on the LCD screen and the media door opens, insert the desired data cartridge into the media door so that the

write-protect switch is facing out from the autoloader and towards the right.

NOTE: If you are using the Operator's Panel to clean the drive, import the cleaning cartridge only when the operator panel requests it.

You may keep a cleaning cartridge in the autoloader if the backup software can manage the drive cleaning.

7. Repeat steps 5 and 6 as needed for any additional cartridges.

8. Press Cancel when you are done importing cartridges.

9. Verify that the LCD screen shows that the desired slots have cartridges installed.

Importing a Cartridge

Exporting Cartridges

This option moves a cartridge from a specific slot to the media door. To export one or more cartridges from the autoloader, follow these steps:

1. From the Home screen or main menu, press + or - until Commands appears on the top line of the LCD screen, and then press Enter.

2. Press + or - until Export appears on the LCD screen, and then press Enter.

3. Press + or - until the desired slot number appears on the LCD screen, and then press Enter. You are not given the option to export from an empty slot.

4. When Remove Cartridge appears on the LCD screen and the cartridge is ejected through the media door, remove the exported cartridge from the

autoloader, and then press Enter.

5. Repeat steps 3 and 4 as needed for any additional cartridges.

6. Press Cancel when you are finished exporting cartridges.

7. Make sure the LCD screen indicates that the desired slots contain cartridges.

Exporting a Cartridge

Loading Cartridges

This option loads a cartridge from the autoloader carousel into the tape drive. To use this option, follow these steps:

1. From the Home screen or main menu, press + or - until Commands appears on the top line of the LCD screen, and then press Enter.

2. Press + or - until Load Cartridge appears on the LCD screen, and then press Enter.

3. Press + or - until the desired slot number appears on the LCD screen, and then press Enter. The slot number you select indicates the cartridge to be

loaded into the tape drive.

NOTE: Only slot numbers that contain cartridges are displayed.

4. Status messages will be displayed while the cartridge is loading. Drive Stopped will be displayed when the operation is complete.

5. Press Cancel when you are finished loading the cartridge.

Unloading Cartridges

This option unloads the cartridge from the tape drive into its original slot. To use this option, follow these steps:

1. From the Home screen or main menu, press + or - until Commands appears on the top line of the LCD screen, and then press Enter.

2. Press + or - until Unload Cartridge appears on the LCD screen. Press Enter to unload the cartridge from the tape drive.