Dell PowerVault 211S 교체 지침 매뉴얼 - 페이지 2
{카테고리_이름} Dell PowerVault 211S에 대한 교체 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault 211S 14 페이지. Dell powervault 20xs storage systems enclosure services
expander module installation
Dell PowerVault 211S에 대해서도 마찬가지입니다: 랙 설치 매뉴얼 (26 페이지), 매뉴얼 (9 페이지), 업데이트 (4 페이지), 구성 (2 페이지), 설치 매뉴얼 (48 페이지)
페이지 인쇄
2
Dell PowerVault 2xxS Storage Systems SCSI Backplane Board Replacement Instructions
SCSI Backplane Replacement Overview
Use the following procedures, in the order listed, to replace the SCSI back-
plane board.
1. Remove the hard-disk drives.
4. Remove the enclosure services modules or enclosure services expander
modules.
9. Install the dual-bus split backplane module on the replacement SCSI back-
plane board.
11. Install the enclosure services or enclosure services expander modules.
Each procedure is described in the following sections.
Remove the SCSI Hard-Disk Drives
CAUTION: Note the location of the SCSI hard-disk drives as you
remove them from the drive bays. During the installation procedure
(found later in this document), you must return the SCSI hard-disk
drives to the same drive bays from which they were removed.
To remove the SCSI hard-disk drives from the drive bays, perform the following
steps.
NOTE: The storage system comes with either a silver, swing-out lock bar or a
black, removable lock bar, which secures the hard-disk drives in their drive bay
slots.
1. Using the key, unlock the keylock.
2. For a storage system with the silver, swing-out lock bar, using your finger-
tips, tap up on the lock bar. The lock bar easily swings out and down, just
below the level of the drive bays (see Figure 1).