Dell PowerVault DL4000 배포 매뉴얼 - 페이지 7

{카테고리_이름} Dell PowerVault DL4000에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DL4000 22 페이지. Setting up your dell powervault dl4000 backup to disk appliance
Dell PowerVault DL4000에 대해서도 마찬가지입니다: 핸드북 (28 페이지), 릴리스 노트 (11 페이지), 시작하기 매뉴얼 (10 페이지), 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 시스템 시작하기 (2 페이지)

페이지 인쇄

Figure 1. Setting the PowerVault MD1200 Storage Enclosure Configuration Switch

1. configuration switch

Connecting The Storage Enclosure To The PowerVault DL4000 System

Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the PowerVault DL4000 system to the

primary Enclosure Management Module (EMM) SAS In port of the storage enclosure. For more information, see the

figure below.

Figure 2. Connecting the SAS Cable From the PowerVault DL4000 System to the PowerVault MD1200 Storage Enclosure

Connecting The Cable Management Arm (Optional)

If the appliance includes a cable management arm (CMA), locate the CMA

CMA kit and follow the instructions to install the CMA.

Turning On The DL Backup To Disk Appliance

After cabling the appliance, turn on the MD1200 storage enclosure, and then turn on the PowerVault DL4000 system.

NOTE: It is recommended that you connect the appliance to an uninterrupted power supply (UPS) for maximum

reliability and availability. For more information, see your system's

Installation Instructions that shipped with the

Owner's Manual at dell.com/support/manuals.