Dell PowerVault NX1950 중요 정보 매뉴얼 - 페이지 17

{카테고리_이름} Dell PowerVault NX1950에 대한 중요 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault NX1950 26 페이지. For vmware esx server software
Dell PowerVault NX1950에 대해서도 마찬가지입니다: 배포 매뉴얼 (34 페이지), 시작하기 (49 페이지), 설치 및 문제 해결 매뉴얼 (48 페이지), 배포 매뉴얼 (38 페이지), 업그레이드 매뉴얼 (18 페이지), 참조 매뉴얼 (4 페이지), 설정 (2 페이지), 사용 (2 페이지), 구성 매뉴얼 (11 페이지)

9 The Configure or Skip RAID window appears. Perform the following

steps:

Select one of the following options, and then click Continue:

•

Configure RAID

•

Skip RAID configuration

NOTE:

both the internal hard disk drives, and this is the supported

hardware configuration for your system.

If you selected Skip RAID configuration, go to step 10.

If you selected Configure RAID, configure RAID with one of the

following options:

•

Click Go to Advanced Wizard at the top left of the page and

follow the prompts.

•

Select a RAID level and click Continue.

NOTE:

boot disk.

The RAID configuration summary appears.

Click Continue.

The following message appears:

All existing virtual disk(s) on this

controller will be deleted and all data will

be lost.

Click OK to continue.

The Select an Operating System to Install window appears.

10 To set up a new boot partition, select the appropriate file system and

size for your partition and click Continue.

NOTICE:

window appears. Click Continue. Server Assistant deletes all existing

partitions on the hard drive.

NOTE:

NTFS-NT file system.

The Network Adapter(s) configuration window appears.

Your system was pre-configured with hardware RAID1 using

Select RAID1 to ensure adequate redundancy for the

If the hard drive has a partition, the Confirm to delete partition

For maximum system security, Dell recommends selecting

Important Information