Dell PowerVault RD1000 사용자 설명서 - 페이지 10

{카테고리_이름} Dell PowerVault RD1000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault RD1000 29 페이지. Usb 3.0 performance considerations
Dell PowerVault RD1000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (35 페이지), 시작하기 매뉴얼 (20 페이지), 중요 정보 매뉴얼 (7 페이지), 보충 설명서 (8 페이지), 시작하기 매뉴얼 (4 페이지), 시작하기 매뉴얼 (35 페이지)

Installation Instructions

1. Carefully unpack the unit and accessories.

2. Turn off the computer.

3. Open the computer cover, using a screwdriver if necessary.

4. Mount the unit. Slide the RD1000 unit into an unused drive bay until the bezel is flush with the

front of the computer. Secure the unit using mounting screws, being careful not to over-

tighten the screws (see

5. Attach the power cable to the power connector (see

6. Connect the SATA data cable to the SATA data connector (see

7. Check all cables in your computer system. Before you reinstall your computer cover ensure

that all cables are correctly routed so that they will not bind or become crimped. Also, make

sure that no cables have loosened during the installation.

8. Replace your computer cover.

9. Turn on the computer.

10. During power-up press F2 key, or other hot key, to enter BIOS set up mode. Enable the SATA

port connected to your RD1000 unit. Save changes and exit from BIOS.

11. If running Windows install the RD1000 software (see "Installing Unit Software for Windows").

12. If you are using the Linux operating system see the appendix "Using the Linux Operating

System".

NOTE: If you choose to install a new operating system on your computer with an RD1000 unit

attached, make sure the cartridge is removed. This prevents the operating system from confusing

the removable drive with the system drive.

Figure 1. RD1000 Internal SATA Connectors

3.5-inch Internal SATA Drive

1 Mounting Screws

2 Power Adapter Cable

3 Mounting Holes

4 SATA Data Cable

Figure 1

below).

Figure 1

below).

Figure 1

below).

5.25-inch Internal SATA Drive