Dell PowerVault RD1000 사용자 설명서 - 페이지 20

{카테고리_이름} Dell PowerVault RD1000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault RD1000 29 페이지. Usb 3.0 performance considerations
Dell PowerVault RD1000에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (35 페이지), 시작하기 매뉴얼 (20 페이지), 중요 정보 매뉴얼 (7 페이지), 보충 설명서 (8 페이지), 시작하기 매뉴얼 (4 페이지), 시작하기 매뉴얼 (35 페이지)

4. Re-start your computer to reset the RD1000 unit. If using the RD1000 External device, re-plug

in the power cable for the unit and then re-start your computer.

NOTE: When the emergency eject is used the computer's operating system will lose recognition of

the RD1000 media. Therefore, one of the following options can be preformed to restore

recognition.

1. Re-start the computer (recommended).

2. Follow steps 1-4 in "The Unit does Not Appear in the Device Manager (Windows)" section if

re-starting the computer is not desired.

The Unit Does Not Appear in the Device Manager (Windows)

If the unit does not appear in the Windows Device Manager and the power indicator is green, follow

these steps to rescan the hardware:

1. Bring up the Device Manager:

1. Right-click on My Computer

2. Select Manage

3. Select Device Manager

2. Right-click on the top folder (this should be your computer's name).

3. Select Scan for Hardware Changes.

4. You should see your RD1000 device listed under Disk drives. If the device does not appear,

re-start the computer.

RD1000 Internal Drive

Some system SATA ports do not by default operate in DMA mode for the RD1000 Internal device. This

results in slower performance and weaker data protection. Reinstall the unit software for Windows to

set the SATA ports to the correct mode. Refer to

RD1000 External Drive

The RD1000 External device may appear slow based on the type of USB port the device is attached

to.

a) If your RD1000 drive supports USB 3.0 make sure your unit is connected to a USB 3.0 port instead

of a USB 2.0 port. For best performance, connect directly to a USB 3.0 root hub on the PC and not an

external hub.

NOTE: If your host system does not support USB 3.0, then a host adapter card supporting USB

3.0 may be required for your PC.

"Installing Unit Software for

Windows" section.