Dell N2128PX-ON 소프트웨어 및 펌웨어 업그레이드 - 페이지 5
{카테고리_이름} Dell N2128PX-ON에 대한 소프트웨어 및 펌웨어 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell N2128PX-ON 14 페이지.
Dell N2128PX-ON에 대해서도 마찬가지입니다: 펌웨어 업그레이드 (14 페이지)
페이지 인쇄
Upgrade Dell EMC Networking N2128PX-ON Switches
How to Access Serial Console Port on N2128PX-ON Switches
NOTE:
How to access serial console port of the N2128PX-ON switch?
Use a supplied "RJ45 Yost to DB9 serial cable" to access the serial console.
Connect the RJ45 end of the cable to the RJ45 serial console port and the DB9 connector to your PC.
Download and Install the terminal emulation software on your PC (for example, PuTTY) to access the
serial console with the correct settings (default setting 115200 baud, 8 data bits, no parity bit, 1 stop bit,
and no flow control).
Figure.1 N2128PX‐ON Switch Console Port Location
Upgrade Example for Dell EMC Networking N2128PX-ON Switches
This example shows an annotated upgrade example for a N2128PX-ON switch. This example presumes the
administrator is logged in to the switch via Serial console. You can also follow this upgrade procedure via telnet or
SSH after setting enable password if it is not set so.
1. Back up your configuration. The following commands copy the running-config to a TFTP server:
console#copy running-config tftp://10.10.10.200/myconfig.txt
Mode........................................... TFTP
Set TFTP Server IP............................. 10.10.10.200
TFTP Path...................................... ./
TFTP Filename.................................. myconfig.txt
Data Type...................................... Config Script
Source Filename................................ running-config
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
11062 bytes transferred
File transfer operation completed successfully.
console#
2. Set an enable password and save the configuration (not required if an alternative enable authentication
method is already configured).
console#configure
console(config)# enable password <password>
console(config)# exit
console# copy running-config startup-config
3. Download the 6.5.2.15 firmware image from a TFTP server.
console#copy tftp://10.10.10.200/N2100Stdv6.5.2.15.stk backup
Transfer Mode.................................. TFTP
Server IP Address.............................. 10.10.10.200
Source File Path............................... ./
Source Filename................................ N2100Stdv6.5.2.15.stk
Data Type...................................... Code
Destination Filename........................... backup
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
TFTP Code transfer starting...
28518539 bytes transferred...
File contents are valid. Copying file to flash...
Page 3