Dell N2128PX-ON 소프트웨어 및 펌웨어 업그레이드 - 페이지 7
{카테고리_이름} Dell N2128PX-ON에 대한 소프트웨어 및 펌웨어 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell N2128PX-ON 14 페이지.
Dell N2128PX-ON에 대해서도 마찬가지입니다: 펌웨어 업그레이드 (14 페이지)
Upgrade Dell EMC Networking N2128PX-ON Switches
Upgrade Stack of Dell EMC Networking N2128PX-ON Series Switches
Note on "copy" command from steps 2,3 and 4 in switch upgrade above:
"copy" command will take longer to complete with a stack of switches. This is due to the master switch
copying the software to the member switches. The master switch will display the line "Distributing the
code to the members of the stack!" for several minutes until the copy is done.
"copy" command will copy the software to all the switches as "backup" image
console#show version
Machine Description............... Dell Networking Switch
System Model ID................... N2128PX-ON
Machine Type...................... Dell Networking N2128PX-ON
Serial Number..................... 15114M0002LF
Manufacturer...................... 0xbc00
Burned In MAC Address............. 001E.C9E5.BD0F
System Object ID.................. 1.3.6.1.4.1.674.10895.3066
SOC Version....................... BCM56150_A0
HW Version........................ 1
CPLD Version...................... 16
unit active
---- ----------- ----------- -------------- --------------
1
6.3.6.9
2
6.3.6.9
3
6.3.6.9
console# boot system backup
Activating image backup ..
console#show version
Machine Description............... Dell Networking Switch
System Model ID................... N2128PX-ON
Machine Type...................... Dell Networking N2128PX-ON
Serial Number..................... 15114M0002LF
Manufacturer...................... 0xbc00
Burned In MAC Address............. 001E.C9E5.BD0F
System Object ID.................. 1.3.6.1.4.1.674.10895.3066
SOC Version....................... BCM56150_A0
HW Version........................ 1
CPLD Version...................... 16
unit active
---- ----------- ----------- -------------- --------------
1
6.3.6.9
2
6.3.6.9
3
6.3.6.9
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n) y
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n) y
After the stack of switches has finished rebooting, log in and verify that the firmware has been updated to the
version using the show version command. A single switch will typically reboot in around two minutes. A
6.5.2.15
stack may take significantly longer to complete the upgrade process.
backup
current-active next-active
6.5.2.15
6.3.6.9
6.5.2.15
6.3.6.9
6.5.2.15
6.3.6.9
backup
current-active next-active
6.5.2.15
6.3.6.9
6.5.2.15
6.3.6.9
6.5.2.15
6.3.6.9
6.3.6.9
6.3.6.9
6.3.6.9
6.5.2.15
6.5.2.15
6.5.2.15
Page 5