Dell Networking S4810 구성 매뉴얼 - 페이지 11

{카테고리_이름} Dell Networking S4810에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking S4810 17 페이지. Open networking
Dell Networking S4810에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 매뉴얼 (42 페이지), 구성 매뉴얼 (17 페이지), 시작하기 매뉴얼 (16 페이지)

페이지 인쇄

Configure Data Center Bridging (DCB) (Optional)

To enable DCB mode on the switch, use the following commands.

Note: You must complete the Dell recommended switch configuration steps in sections 2.1 to 2.12

before configuring the switch for DCB mode.

3.1

Disable 802.3x flowcontrol on SFP+ ports

FTOS#configure

FTOS(conf)#interface range tengigabitethernet 0/0 - 47

FTOS(conf-if-range-te-0/0-47)#no flowcontrol rx on tx off

3.2

Disable 802.3x flowcontrol on QSFP ports

FTOS#configure

FTOS(conf)#interface range fortyGigE 0/48 – 60

FTOS(conf-if-range-fo-0/48-52)#no flowcontrol rx on tx off

3.3

Create tagged VLAN for all ports and port-channels

FTOS#configure

FTOS(conf)#interface vlan vlan-id

Note: You must supply a VLAN id. The valid range is 2-4093.

FTOS (conf-if-vl-vlan-id*)#tagged tengigabitethernet 0/0-47

FTOS (conf-if-vl-vlan-id*)#tagged port-channel 1

3.4

Configure priority groups and policies

FTOS#configure

FTOS(conf)#dcb-input pfc

FTOS(conf-dcb-in)#pfc priority 4

FTOS(conf-dcb-in)#exit

FTOS(conf)#priority-group iSCSI

SCG1000

Force10 S4810 Configuration Guide