Dell Networking S4810 구성 매뉴얼 - 페이지 8

{카테고리_이름} Dell Networking S4810에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Networking S4810 17 페이지. Open networking
Dell Networking S4810에 대해서도 마찬가지입니다: 사양 (2 페이지), 설치 매뉴얼 (42 페이지), 구성 매뉴얼 (17 페이지), 시작하기 매뉴얼 (16 페이지)

페이지 인쇄

2.4

Configure route for OOB management port (optional)

Force10(conf)#management route X.Y.Z.0 /24 A.B.C.1

Note: X.Y.Z.0 is the network your management system is connecting from and A.B.C.1 is the gateway for

the switch. If your management system is on the same subnet as the switch, the previous step may be

omitted. The example above assumes a class C subnet mask.

2.5

Configure login credentials

FTOS(conf)#username admin privilege 15 password 0 yourpassword

FTOS(conf)#enable password level 15 0 yourpassword

2.6

Enable iSCSI optimization feature

This feature is enabled when EqualLogic arrays are connected. It automatically performs the following:

• Configures jumbo frames to 12k on all ports.

• Disables unicast storm.

• Enables spanning tree portfast on ports connected to EqualLogic arrays.

• Configures flowcontrol on all ports (rx on tx off).

Note: Spanning tree portfast must be manually configured for host facing ports. Refer to section 2.8.

FTOS#configure

FTOS(conf)#iscsi enable

FTOS(conf)#exit

2.7

Enable switch ports

Option 1: You can enable the array or host facing ports individually.

Note: This method is more secure than Option 2.

FTOS#configure

FTOS(conf)#interface tengigabitethernet 0/0

FTOS(conf-if-te-0/0)#switchport

FTOS(conf-if-te-0/0)#no shutdown

FTOS(conf-if-te-0/0)#exit

FTOS(conf)#exit

SCG1000

Force10 S4810 Configuration Guide