Dell PowerConnect 8164F 구성 매뉴얼 - 페이지 11

{카테고리_이름} Dell PowerConnect 8164F에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect 8164F 17 페이지. Powerconnect 8100 series high-performance 10/40 gbe enterprise switches
Dell PowerConnect 8164F에 대해서도 마찬가지입니다: 사양 (3 페이지)

페이지 인쇄

2.10

Configure spanning tree portfast on edge ports

Note: If iSCSI optimization is enabled, spanning tree portfast is automatically configured on ports

connected to EqualLogic arrays. These manual steps must be performed on switch ports connected to

hosts servers.

console#configure

console(config)#interface range tengigabitethernet all

console(config-if)#spanning-tree portfast

console(config-if)#exit

2.11

Configure QSFP ports for LAG

These commands assign 40Gb QSFP ports to the Port Channel.

console(config)#interface range fortygigabitethernet 1/0/1-2

Note: Port numbering for the 40Gb QSFP ports may vary by switch model and module configuration.

Confirm the correct port range for your configuration.

console(config-if)#no spanning-tree portfast

console(config-if)#channel-group 1 mode active

console(config-if)#exit

2.12

Save configuration

console#copy running-config startup-config

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to save? (y/n)y

2.13

Configure additional switch

Repeat the commands from Section 2 to configure the second switch.

Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a

non-default VLAN, refer to the documentation for your switch.

SCG1001

Dell Networking N4000 Series and Dell PowerConnect 8100 Series Configuration Guide