Dell S3100 Series 시작하기 매뉴얼 - 페이지 18

{카테고리_이름} Dell S3100 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S3100 Series 27 페이지.
Dell S3100 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (46 페이지), 설치 매뉴얼 (45 페이지)

페이지 인쇄
Dell S3100 Series 시작하기 매뉴얼
NOTE: You must have a password configured on a virtual terminal line
before you can Telnet into the system. Therefore, use a console
connection when connecting to the system for the first time. Before
starting this procedure, be sure that you have a terminal emulation
program already installed on your PC.
NOTE: If you are configuring a stack of switches, serial console access
to the stack manager is available from any serial port using the local CLI.
Only one serial console session at a time is supported.
1.
Install an RJ-45 copper cable into the console port. Use a rollover cable
to connect the console port to a terminal server.
2.
Connect the other end of the cable to the DTE terminal server.
3.
Set the default terminal settings as follows.
•
9600 baud rate.
•
No parity.
•
Eight data bits.
•
One stop bit.
•
No flow control.
Accessing the RJ-45 Console Port with a
DB-9 Adapter
If the DTE has a DB-9 interface, you can connect to the console using an
RJ-45 to DB-9 adapter along with the RJ-45 rollover cable.
Table 1. Pin Assignments Between the Console and a DTE Terminal Server
Console Port RJ-45 to
RJ-45
Rollover
Cable
Signal
RJ-45 Pinout RJ–45 Pinout DB-9 Pin
RTS
1
NC
2
TxD
3
GND
4
GND
5
18
RJ-45 to
RJ-45 to
RJ-45
DB-9 Adapter
Rollover
Cable
8
8
7
6
6
2
5
5
4
5
Terminal
Server Device
Signal
CTS
DSR
RxD
GND
GND
Installing the Software