Dell S3100 Series 시작하기 매뉴얼 - 페이지 19

{카테고리_이름} Dell S3100 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S3100 Series 27 페이지.
Dell S3100 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (46 페이지), 설치 매뉴얼 (45 페이지)

페이지 인쇄
Dell S3100 Series 시작하기 매뉴얼
Console Port RJ-45 to
RJ-45
Rollover
Cable
Signal
RJ-45 Pinout RJ–45 Pinout DB-9 Pin
RxD
6
NC
7
CTS
8

Default Configuration

A version of Dell Networking OS is pre-loaded on the system; however, the
system is not configured when you power up for the first time (except for the
default host name, which is Dell).
You must configure the system using the CLI.

Configuring Layer 2 (Data Link) Mode

To enable Layer 2 data transmissions through an individual interface, use the
switchport command in INTERFACE mode.
You cannot configure switching or Layer 2 protocols such as spanning tree
protocol (STP) on an interface unless the interface has been set to Layer 2
mode.
1.
Enable the interface.
INTERFACE mode
no shutdown
2.
Place the interface in Layer 2 (switching) mode.
INTERFACE mode
switchport
To view the interfaces in Layer 2 mode, use the show interfaces
switchport command in EXEC mode.
Installing the Software
RJ-45 to
RJ-45 to
RJ-45
DB-9 Adapter
Rollover
Cable
3
3
2
4
1
7
Terminal
Server Device
Signal
TxD
DTR
RTS
19