Dell S4048-ON 구성 매뉴얼 - 페이지 10
{카테고리_이름} Dell S4048-ON에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S4048-ON 19 페이지. Enterprise switches
Dell S4048-ON에 대해서도 마찬가지입니다: 구성 매뉴얼 (30 페이지), 문제 해결 매뉴얼 (29 페이지)
페이지 인쇄
2.9
Configure spanning tree on edge ports
Dell(conf-if-range-te-1/1-48)#spanning-tree rstp edge-port
Dell(conf-if-range-te-1/1-48)#exit
Dell(conf)# protocol spanning-tree rstp
Dell(conf-rstp)#no disable
Dell(conf-rstp)#exit
2.10
Configure port channel for LAG
These commands configure the switch interconnect as a LAG.
Dell(conf)#interface Port-channel 1
Dell(conf-if-po-1)#mtu 12000
Dell(conf-if-po-1)#switchport
Dell(conf-if-po-1)#no shutdown
Dell(conf-if-po-1)#exit
2.11
Configure QSFP ports for LAG
These commands assign 40Gb QSFP ports to the Port Channel.
Dell(conf)#interface range fortyGigE 1/49 , fortyGigE 1/50
Dell(conf-if-range-fo-1/49,fo-1/50)#no ip address
Dell(conf-if-range-fo-1/49,fo-1/50)#mtu 12000
Dell(conf-if-range-te-1/49,fo-1/50)#no shutdown
Dell(conf-if-range-fo-1/49,fo-1/50)#flowcontrol rx on tx off
Dell(conf-if-range-fo-1/49,fo-1/50)#port-channel-protocol lacp
Dell(conf-if-range-fo-1/49,fo-1/50-lacp)#port-channel 1 mode active
Dell(conf-if-range-fo-1/49,fo-1/50-lacp)#exit
Dell(conf-if-range-fo-1/49,fo-1/50)#exit
Dell(conf)#exit
2.12
Save configuration
Dell#copy running-config startup-config
2.13
Configure additional switch
Repeat the commands from sections 2.2–2.13 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in
a non-default VLAN, refer to the documentation for your switch.
10
SCG1026
Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs