Dell S4048-ON 구성 매뉴얼 - 페이지 8
{카테고리_이름} Dell S4048-ON에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S4048-ON 19 페이지. Enterprise switches
Dell S4048-ON에 대해서도 마찬가지입니다: 구성 매뉴얼 (30 페이지), 문제 해결 매뉴얼 (29 페이지)
페이지 인쇄
2
Dell recommended switch configuration
These steps show you how to configure two S4048-ON switches with a Link Aggregation Group (LAG).
The switches are interconnected using two of the 40GbE Quad Small Form-factor Pluggable (QSFP) uplink
ports, and the LAG is configured for Dynamic Link Aggregation Control Protocol (LACP).
2.1
Hardware configuration
1.
Power on the two switches.
2. Connect a serial cable to the serial port of the first switch.
3. Using PuTTY or another terminal utility, open a serial connection session to the switch.
4. Open your terminal emulator and configure it to use the serial port (usually COM1 but this may vary
depending on your system). Configure serial communications for 115200,N,8,1 and no flow control.
5. Connect the (QSFP) LAG cables between the switches by connecting port 49 on switch 1 to port 49
on switch 2 and port 50 on switch 1 to port 50 on switch 2. See this configuration in Figure 1.
2.2
Delete startup configuration
Note: The following commands will delete all configuration settings.
Dell>enable
Dell#delete startup-config
Proceed to delete startup-config [confirm yes/no]yes
Dell#reload
System configuration has been modified. Save? [yes/no]no
Proceed with reload [confirm yes/no]yes
Note: The switch will reboot.
2.3
Configure out of band (OOB) management port
Dell>enable
After the startup configuration is deleted, the factory default Enable mode password is calvin.
Dell>#configure
Dell(conf)#interface ManagementEthernet 1/1
Dell(conf-if-ma-1/1)#no shutdown
Dell(conf-if-ma-1/1)#ip address <ip address> <mask>
Dell(conf-if-ma-1/1)#exit
8
SCG1026
Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs