Dell S4048-ON 구성 매뉴얼 - 페이지 11

{카테고리_이름} Dell S4048-ON에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell S4048-ON 19 페이지. Enterprise switches
Dell S4048-ON에 대해서도 마찬가지입니다: 구성 매뉴얼 (30 페이지), 문제 해결 매뉴얼 (29 페이지)

페이지 인쇄

Configure Data Center Bridging (DCB) (optional)

To enable DCB mode on the switch, use the following commands.

Note: You must complete the Dell recommended switch configuration steps in Sections 2.1 to 2.12

before configuring the switch for DCB mode.

3.1

Disable 802.3x flowcontrol on SFP+ ports

Dell#configure

Dell(conf)#interface range tengigabitethernet 1/1–1/48

Dell(conf-if-range-te-1/1-48)#no flowcontrol rx on tx off

Dell(conf-if-range-te-1/1-48)#exit

3.2

Disable 802.3x flowcontrol on QSFP ports

Dell(conf)#interface range fortyGigE 1/49 , fortyGigE 1/50

Dell(conf-if-range-fo-1/49-50)#no flowcontrol rx on tx off

Dell(conf-if-range-fo-1/49-50)#exit

3.3

Enable DCB and reload

Dell(conf)#dcb enable

Dell(conf)#exit

Dell#copy running-config startup-config

Dell#reload

Note: After confirming reload request, the switch will reboot.

3.4

Create tagged VLAN for all ports and port-channels

Dell#configure

Dell(conf)#interface vlan vlan-id

Note: You must supply a VLAN id. The valid range is 2-4093.

Dell (conf-if-vl-vlan-id*)#no shutdown

Dell (conf-if-vl-vlan-id*)#tagged tengigabitethernet 1/1–1/48

Dell (conf-if-vl-vlan-id*)#tagged port-channel 1

Dell (conf-if-vl-vlan-id*)#exit

SCG1026

Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs