Dell S4048-ON Configuratiehandleiding - Pagina 8

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Dell S4048-ON. Dell S4048-ON 19 pagina's. Enterprise switches
Ook voor Dell S4048-ON: Configuratiehandleiding (30 pagina's), Handleiding voor probleemoplossing (29 pagina's)

Pagina afdrukken

Dell recommended switch configuration

These steps show you how to configure two S4048-ON switches with a Link Aggregation Group (LAG).

The switches are interconnected using two of the 40GbE Quad Small Form-factor Pluggable (QSFP) uplink

ports, and the LAG is configured for Dynamic Link Aggregation Control Protocol (LACP).

2.1

Hardware configuration

Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using PuTTY or another terminal utility, open a serial connection session to the switch.

4. Open your terminal emulator and configure it to use the serial port (usually COM1 but this may vary

depending on your system). Configure serial communications for 115200,N,8,1 and no flow control.

5. Connect the (QSFP) LAG cables between the switches by connecting port 49 on switch 1 to port 49

on switch 2 and port 50 on switch 1 to port 50 on switch 2. See this configuration in Figure 1.

2.2

Delete startup configuration

Note: The following commands will delete all configuration settings.

Dell>enable

Dell#delete startup-config

Proceed to delete startup-config [confirm yes/no]yes

Dell#reload

System configuration has been modified. Save? [yes/no]no

Proceed with reload [confirm yes/no]yes

Note: The switch will reboot.

2.3

Configure out of band (OOB) management port

Dell>enable

After the startup configuration is deleted, the factory default Enable mode password is calvin.

Dell>#configure

Dell(conf)#interface ManagementEthernet 1/1

Dell(conf-if-ma-1/1)#no shutdown

Dell(conf-if-ma-1/1)#ip address <ip address> <mask>

Dell(conf-if-ma-1/1)#exit

SCG1026

Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs