Dell S4048-ON Yapılandırma Kılavuzu - Sayfa 8

Anahtar Dell S4048-ON için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Dell S4048-ON 19 sayfaları. Enterprise switches
Ayrıca Dell S4048-ON için: Yapılandırma Kılavuzu (30 sayfalar), Sorun Giderme Kılavuzu (29 sayfalar)

Dell S4048-ON Yapılandırma Kılavuzu
2

Dell recommended switch configuration

These steps show you how to configure two S4048-ON switches with a Link Aggregation Group (LAG).
The switches are interconnected using two of the 40GbE Quad Small Form-factor Pluggable (QSFP) uplink
ports, and the LAG is configured for Dynamic Link Aggregation Control Protocol (LACP).
2.1

Hardware configuration

1.
Power on the two switches.
2. Connect a serial cable to the serial port of the first switch.
3. Using PuTTY or another terminal utility, open a serial connection session to the switch.
4. Open your terminal emulator and configure it to use the serial port (usually COM1 but this may vary
depending on your system). Configure serial communications for 115200,N,8,1 and no flow control.
5. Connect the (QSFP) LAG cables between the switches by connecting port 49 on switch 1 to port 49
on switch 2 and port 50 on switch 1 to port 50 on switch 2. See this configuration in Figure 1.
2.2

Delete startup configuration

Note: The following commands will delete all configuration settings.
Dell>enable
Dell#delete startup-config
Proceed to delete startup-config [confirm yes/no]yes
Dell#reload
System configuration has been modified. Save? [yes/no]no
Proceed with reload [confirm yes/no]yes
Note: The switch will reboot.
2.3

Configure out of band (OOB) management port

Dell>enable
After the startup configuration is deleted, the factory default Enable mode password is calvin.
Dell>#configure
Dell(conf)#interface ManagementEthernet 1/1
Dell(conf-if-ma-1/1)#no shutdown
Dell(conf-if-ma-1/1)#ip address <ip address> <mask>
Dell(conf-if-ma-1/1)#exit
8
SCG1026
Dell Networking S4048-ON Switch Configuration Guide for PS Series SANs