EarthWay 2170 조립 지침 매뉴얼 - 페이지 7

{카테고리_이름} EarthWay 2170에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthWay 2170 10 페이지. Commercial broadcast spreader with side spread control
EarthWay 2170에 대해서도 마찬가지입니다: 조립 및 작동 지침 매뉴얼 (6 페이지), 조립 및 작동 지침 매뉴얼 (8 페이지), 사용 설명서 (8 페이지), 조립 지침 매뉴얼 (12 페이지), 조립 및 작동 지침 매뉴얼 (6 페이지)

Assembly and Operation Instructions

CALIBRATION

Pull lever back to setting "30" as

Step 15:

shown. Next push pivot & bracket forward so

that the shut off plate in the hopper is in the full

open position. REMEMBER SETTING "30" ON

THE FLOW CONTROL LEVER MUST PLACE THE

SHUT-OFF PLATE IN THE FULL OPEN POSITION

TO BE PROPERLY CALIBRATED. Now tighten the

nuts against the PIVOT BRACKET to prevent

change in calibration.

NOTE: Tension on the flow control lever may

be adjusted by tightening or loosening the

tension nut as shown.

Insert agitator to pinion shaft on

Step 16:

inside of hopper.

Note: the position of flat side of the agitator.

This pin should be installed as shown.

2170_M52164_RevJune2021

PAGE 7