360 Vision Visiondome-VR 설치 및 구성 매뉴얼 - 페이지 13

{카테고리_이름} 360 Vision Visiondome-VR에 대한 설치 및 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 360 Vision Visiondome-VR 16 페이지.

360 Vision Visiondome-VR 설치 및 구성 매뉴얼
Visiondome VR Installation Manual Ver 2.7
Settings Menu
Offers more camera options.
General 1
Digital Zoom - Use this option to enable or disable digital zoom.
White Balance - Change the camera white balance settings to suit the area.
Line Lock - Used to line lock the camera.
Line Phase - Can be used to manually adjust the line phase.
Video Gain - Used to adjust the video level to suit different lengths of coax cable.
Video Lift - Used to adjust the frequency of the video level to suit different lengths of coax cable.
Wide Dynamic - Enable WDR. Options available are ON, Auto and Off. Default is off.
General 2
Auto Flip - Use this option to set how the camera behaves when full tilt down is reached.
Semi - Requires a second tilt down command when at full tilt down to spin camera 180°.
Full - Automatically spins the camera 180°
Proportional - Automatically reduces/increases pan/tilt speed depending on zoom ratio.
Freeze Presets - This option freezes the image, when moving between presets.
Zoom Speed - Use to set prefered zoom speed, 5 is slow and 8 is fast.
OSD Preset Six - Go into OSD using preset 95 and you can switch off OSD access using preset 6.
Ambient Lighting - Sets how the camera will focus (when in mono) to suit the light source in the
scene. If this is set incorrectly the image may not be in focus.
PEL/VCL AF AI PTZ - Auto focus/iris will activate when PTZ is used, can be switched off. Default is
on. Pelco and VCL protocols only.
Night
Col/Mono Level - Col/Mono level settings can be changed to suit the site requirements. Options are
dark, medium and light. Default is dark. This sets when the camera goes into 'mono mode'.
Mono On - Range is 7 to 25. A lower value will set the level on when the scene is brighter, a higher
value will set the level on when the scene is darker.
Mono Off - Range is 1 to 20. A lower value will set the level off when the scene is brighter, a higher
value will set the level off when the scene is darker.
Brightness - Can be used to artificially brighten the image, options are low, medium and bright.
Bright Control - Options are automatic or preset seek activation.
(See also Special Presets page 14).
Noise Reduction - Used to reduce noise with scenes of low illumination. NR must be set to suit the
environment. Default is off.
Aperture - Can be used to increase the picture detail. Default is 10.
Shutter
Fast Shutter - Option to enable fast shutter and set speed of the shutter.
Slow Shutter - Option to alter the slow shutter speed. Altering this figure will have an effect on the low
light capabilities of the camera.
Text Field Menu
Navigate along alpha-numeric characters and use zoom in to select. Choose text position by inputting x and y
co-ordinates. Set text display to on, if required.
Servicing
Power Reset - This will reboot the camera, no settings will be lost.
Factory Reset - This will reboot the camera and all the settings will be lost.
Visiondome VR Software Version - This shows the software version of the camera.
© 360 Vision Technology Ltd.
Page 13