Allmatic AS24 설치 매뉴얼 - 페이지 8

{카테고리_이름} Allmatic AS24에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allmatic AS24 10 페이지. Control unit for 1-2 motors 24vdc

14. Advanced functions

Through the 8-position dip switch, it is possible to personalize further the automation functions. As standard the control panel leaves the factory

with all the main functions already set, however, it is always possible to modify them by following the table:

Dip No.

modality of functioning

learning of the courses

electrical lock + water hammer

14.1 Modality of functioning

Setting the dip n° 1 on ON and the dip n° 2 on OFF, the manual functioning is enabled. This functioning allows the displacement of the wing with

the red and blue keys present on the card (see paragraph 4)

14.2 Strokes learning

Setting the dip n° 1 on OFF and the dip n° 2 on ON, t he learning of the strokes is enabled. This functioning allows to learn the courses and the

phase shift of the wings (see paragraph 6).

Setting the dip n° 1 on ON and the dip n° 2 on ON, the pedestrian opening is enabled. This functioning allows to learn the opening of the first wing

when the pedestrian opening key is pressed (see paragraph 11).

14.3 Pre – flashing

Setting the dip nr.3 on ON the pre – flashing is enabled. This function means that before any movement there will be a brief flashing in order to

indicate the movement is about to begin. Remember to turn the control unit off and then on again after modifying the dip switch's configuration.

14.4 Condominium function

Every command sent via radio or with the step by step buttons and/or pedestrian buttons will only open the door. Reclosure is entrusted to the

automatic reclosure function, which must be activated since all closure command are ignored. In case the condominium function is active and the

automatic reclosure is deactivated by means of the respective regulation trimmer (turned completely in clockwise sense), the control panel puts

itself in state of signalled alarm, with door closed, through fast blinkings of the flashing light. Set dip n° 4 on ON to activate the condominium

function.

14.5 Water hammer and electrical lock

If the automation is equipped with an electro lock it is advisable that, with the gate closed, the motor acts in closure for a short time before starting

the opening phase. This functions allows you to un-lock the electro lock even in harsh weather conditions (e.g. ice). In order to activate the water

hammer set dip no. 5 to ON.

14.6 Photocells check

This control unit is equipped with a function which allows you to carry out a check of the photocells operation before any turning on of the motor. In

this way there is the possibility of increasing the safety of the system in case of photo device damaging (for example output relay stuck) or of an

unwanted short – circuit on the photocell input. In case of breakdown, the control panel will signal it through a single flashing when a key is

pressed and no movement will take place. This check is carried out after the control panel has received an order to move, but therefore powering

the motor. Set dip n° 6 on ON to activate the photo cell check.

14.7 Clock function

Setting the dip n° 7 on ON the timing function is a ctivated. The pedestrian input becomes timing input where it is possible to connect a timer for the

programming opening of the gate. The contact is interpreted as request of opening and of permanence on the opening state until the contact

remains closed. When the contact opens, the gate automatically closes.

14.8 Wings number setting

The control unit AS24 can work with 1 or 2 wing gates. This setting is carried out putting the dip n° 8 on OFF if you want a 2 wing functioning and

on ON if you want a single wing functioning. This setting MUST be carried out before the learning of the strokes.

6-1622372

rev.5 04/02/2016

function

Pre-flashing

Condominium function

Photocell check

time set

number of wings

ITA

Dip OFF

Automatic

disabled

Not active

disabled

Not active

2 wings functioning

ENG

FRA

ESP

DEU

POR

Dip ON

Manual

enabled

Active

enabled

Active

1 wing functioning

Pag 8 di 10